Thus far, getting the 2300c up and running has proven to be a bit of a longer running side project than expected.
Part of the juggle:
- Most of my software base targets M68K and system 7: about the time PowerPC support began.
- Most of my media for installing MacOS 9 either can't boot on older than a G3 or is media that can neither be booted nor readily connected to the older hardware.
- Which parts will end up in which machine.
Now that I have a second IDE to SD adapter, I can fit the 2300c with its own internal drive. I'm thinking the larger RAM card from my 230c will get swapped with the 8 MB RAM card from the 2300c. At least if I can get the machine running MacOS 9 or 8.x where memory use will probably be higher. I can't say that I care as much about the modem card given the process to swap that and my lack of a local test loop.
I'm thinking that the 2300c will get nicknamed "Maxwell", after Gundam Wing's Duo Maxwell.
Looking like the next steps will be creating an image for the SD card via emulator or trying to arrange booting my G3 machine and seeing if it can run an install to the 2300c using Target Disk mode and a SCSI connection. In the meantime, I might just see if the 230's system 7 install will boot on the 2300c. If so, a whole lotta Zip disk swapping and multiple partitions might be an effective solution.
While the 2300c has proven to be in much better shape than I expected, the fancier color screen looks like it would benefit from recapping far more than the 230's B&W. Figuring out replacement capacitors though, may be a project for another year. When it comes to the trouble of dismantling that section of PowerBook, it would probably make a good opportunity to do the same to the motherboard. Especially if the PowerPC model also has most of the caps in the same zone near the DC input.
Actually, come to think of it, I believe the baseline floppy setup system 7 that I used for the 230c should be viable if I make a PPC disk utilities floppy to bootstrap from. Decades after the fact, I'm not entirely sure I want to know how well an upgrade process from System 7.x to MacOS 9 would work.